Step-by-step application of the IOD Paint Inlays:

1. Design planning:
   • Define the desired design in advance.
   • Cut the inlay sheets to size using the printed grid lines.
   • For patterns with a repeat, any excess edges can be trimmed so that the individual sheets fit together properly.
2. Apply paint:
   • Apply a generous, even coat of a mineral chalk paint suitable for IOD Paint Inlays.
   • Work in sections; according to the manufacturer, ideally in areas no larger than approximately 30 × 40 cm.
3. Insert inlay:
   • Place the inlay with the motif side down in the still wet paint.
   • You can tell which side is the back by the printed grid pattern.
   • Hold the sheet as taut as possible when placing it, and then make sure it doesn’t shift.
4. Moisten & press on:
   • Lightly moisten the inlay with a fine mist of water.
   • Gently press or dab it with a damp sponge or silicone tool.
   • Apply light, even pressure as you work.
5. Allow to dry:
   • Let the inlay dry for about 10 minutes to an hour, depending on the environmental conditions.
6. Remove the paper:
   • Moisten the paper evenly and let the water soak in for about 30 seconds.
   • Then carefully peel off the paper at a shallow angle.
   • If it doesn’t come off easily, moisten it again and wait a little longer.
7. Refine the design:
   • As long as the transferred pigments can still be reactivated with water, they can be carefully blended or smoothed out.
   • Depending on the desired design, additional colors can be incorporated into the layout.
8. Final drying:
   • Allow your project to dry completely.
   • If the surface still feels cool, this may indicate that moisture is still present.
   • According to the manufacturer, the project should be allowed to dry for at least 24 hours before further work is done. The actual drying time may vary depending on the environment, the surface, and how the paint was applied.